Stippling package for customer supplied gen2 Staccato grips (C2 ODS, Fullsize P, and P tac texture grips). Must separate the grip and lower frame (serialized item) and ship the grip assembly only. Please read all options and descriptions below and contact us with questions before placing an order.
See the bottom of the FAQ page for pictures of each texture! Note that due to the large # of possible options/combinations not every combination will be shown. Please contact us if you want to see a specific set of options.
Factory borders- This is the standard package which includes a full grip reduction, reshaping and blending the corners of the front strap, deep recessed borders, and your choice of logos and texture/finish. We also cut a new border at the base of the front strap to maintain a crisp parallel border across the entire magwell area.
Mod-L Front borders- This is our front strap border option which includes cutting new borders and blending the finger pad area on the front of the grip. This will offer a reduction in width at the sides of the grip where the finger pad was but no material is removed from the front strap to retain structural integrity of the grip. This will allow your strong hand middle finger to be in full contact with textured surface area; greatly increasing control and feel.
Wrap Around rear borders- This is our rear strap border option which allows the most amount of grip reduction possible as the rear of the grip is reduced further. We cut new borders into the backside of the grip, reduce and blend the mainspring housing into the grip and further shape the "shelf" at the backside of the grip which allows more purchase from the palm of your support hand. This is recommended for those that wear a size M or smaller glove.
Factory Gap Borders- This is the factory border option with gap borders. Gap borders are only available on the factory border layout. You will notice the price for gap borders is higher than the normal package/options as this is due to the significant amount of additional labor to achieve the cleanest gap borders as possible.
Logos option- When choosing to keep the Star logo, we will take meticulous care to ensure the condition of the logos remain the same as when received. We will cut and emboss new borders around the star logo and then stipple around the logo to maintain that clean factory look. If you choose to remove the star logo this will allow us to sand that area flush to the grip and blend it like it was never there in the first place.
